The most complex fault rupture ever?

By David Jacobson, Temblor

See earthquakes in New Zealand

During the Kaikoura earthquake, rupture along the Papatea Fault uplifted the shore platform several meters forming a small lagoon. (Photo from: GNS Science)

 

It has been just over four months since the M=7.8 Kaikoura, New Zealand earthquake rattled the country, leaving the landscape scarred, homes destroyed, and cows stranded. Since the quake, approximately 50 people from both New Zealand and overseas institutions have been working to measure exactly what happened. At a presentation a couple days ago, their message was clear, this quake is probably the most complex ever recorded.

The Kaikoura earthquake resulted in a heavily scarred landscape, both due to fault rupture and landslides. (Photo from: New Zealand Geographic)

 

In the immediate aftermath of the quake, scientists at GNS Science in New Zealand knew that something was different. They were recording vastly different magnitudes (From M=6.6 to M=7.8), and there went from being no tsunami warning, to one being issued, to minimal wave action in short succession. Now, the culprit of this confusion appears to be known, 21 different faults over 180 kilometers ruptured in the November 14, 2016 quake.

The Kaikoura earthquake also caused numerous landslide dams to form. This one formed just inland of Kaikoura. (Photo from: New Zealand Geographic)

 

According to GNS scientist Kate Clark, initial estimates suggested that five faults ruptured from south to north in the Kaikoura earthquake. In an interview, Clark said, “we were all a bit bewildered, confused, and also amazed…It was kind of our first clue that this was probably going to be quite a complicated and unusual earthquake.” She was right, as one month later, in December, the number of fault ruptures discovered had risen to nine. Now, with the help of modern technology, Clark says that 21 different faults ruptured, some of which, were not known prior to the earthquake. Another astounding number is that of the 21 faults that ruptured, 14 of them saw ground displacements greater than 1 meter. The most significant of these was along the Kekerengu Fault, where up to 12 meters (39 feet) of horizontal displacement was measured. For comparison, in the 1906 M=7.9 San Francisco earthquake, the maximum displacement was 21 feet near Tomales Bay.

Numerous roads saw significant offset and damage, while others were covered by landslides in the Kaikoura earthquake. (Photo from: New Zealand Geographic)

 

One of the reasons why scientists believe the Kaikoura quake was so complex is because of where it occurred. New Zealand sits on the boundary between the Australian and Pacific plates, meaning seismicity is already significant. However, around Kaikoura, that plate boundary is evolving as to the north, there is the Hikurangi Subduction Zone, and to the south, the Alpine Fault, which is similar to the San Andreas. Because of this, there is both significant compression and shearing. In turn, fault ruptures in this region can be quite complex. Having said that, no one could have predicted this event.

This Temblor map shows the location of the M=7.8 November 14 earthquake. From this map, it can be seen that the quake occurred in a region in between the Alpine Fault and the Hikurangi Subduction Zone, which led scientists to believe that the quake was part of the evolution of the greater plate boundary.

 

References

GNS Science

Radio New Zealand

Stuff.co.nz

USGS