M=6.2 subduction zone earthquake strikes El Salvador

By David Jacobson, Temblor

See earthquakes in El Salvador

Click for Spanish version

El Salvador’s capital city of San Salvador experienced light shaking in today’s M=6.2 offshore earthquake. (Photo from: Lonely Planet)


A M=6.2 earthquake struck off the coast of El Salvador at 4:41 a.m. local time this morning (12 May 2017). According to the USGS, the quake occurred at a depth of 10 km, approximately 75 km offshore. So far, no reports of damage have come in, and the USGS estimates that economic losses should remain minimal, and that there should be no fatalities as only light shaking was felt in the country, including in the capital city of San Salvador, which is home to over 250,000 people.

This Google Earth map shows the location of today’s earthquake relative to the Middle America Trench. Based on the depth (10 km) and location of the earthquake, it likely occurred on the subduction zone, or slightly above it.


Even though the USGS does not have a focal mechanism, based on the earthquake’s depth and location, it likely occurred on the Central American subduction zone or just above it. This analysis was also aided by using the Slab 1.0 model by Gavin Hayes at the USGS (which appears in Temblor as “Megathrust” zones). This model is a compilation of global subduction zones geometries. Based on the geometry of this subducting slab, it should be at a depth of 10-20 km in the location of today’s event.

The Central American subduction zone is a product of the Cocos plate subducting beneath the Caribbean plate at the Middle American Trench at a rate of 72-81 mm/yr. This convergence decreases from south to north, and in the location of today’s quake, the rate is approximately 81 mm/yr. Because of this subduction, there is both a high rate of seismicity throughout Central America, as well as a chain of active volcanoes.

This portion of Central America is no stranger to large earthquakes. In 2001, a M=7.7 offshore of El Salvador, also on the subduction zone, claimed nearly 1,000 lives, generated thousands of landslides, and caused millions in damage. By using the Global Earthquake Activity Rate (GEAR) model, which is available in Temblor, we can determine if today’s quake should be considered surprising or not. The GEAR model uses global strain rates and seismicity since 1977 to forecast the likely earthquake magnitude in your lifetime anywhere on earth. From the GEAR model shown below, we can see that the region is susceptible to M=7.25+ earthquakes, meaning today’s M=6.2 should not be considered alarming. Instead, it should come as a reminder that Central America is highly seismically active. To view the GEAR model, click here.

This Temblor map shows the location of today’s M=6.2 earthquake, as well as Global Earthquake Activity Rate (GEAR) model. This model, which uses global strain rates and seismicity since 1977 to forecast what the likely earthquake magnitude in your lifetime is anywhere on earth shows us that today’s quake should not be considered surprising as the region is prone to M=7.25+ earthquakes. To see the model, click the figure.




Hayes, G. P., D. J. Wald, and R. L. Johnson (2012), Slab1.0: A three-dimensional model of global subduction zone geometries, J. Geophys. Res., 117, B01302, doi:10.1029/2011JB008524.